6.5 Carcano - Hornady .267 Expander Ball Question

[deadwood]

I want to start reloading 6.5 Carcano using the Hornady .267 bullet.
I only have an older RCBS 6.5 die set that has a .264 expander ball.
I would like to know if the Hornady expander ball will fit on the RCBS Spindle.
The thread is a standard 10-32. (See attached photo)
I do not necessarily care about the de-capping pin being different.

I would appreciate it if someone with a Hornady die set could check this out for me.
Perhaps even supply the other thread sizes to compare with the RCBS spindle.
.
http://www.honos.org/photos/spindle.jpg

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.