-
Contributing Member
All I did with all my 303's apart from the 1921 Lithgow
(Which is a safe queen) is carefully and I stress carefully polish the flat & tip of the sear then the same to the "nose" of the cocking piece then the nodes on the trigger as well as polish the retaining pins for the trigger & sear this is done with a small hand held super el' cheapo dremel (as I am really cheap) from Bunnings that stops cold when any type of pressure is put on it took a while to do them, no angles were changed or hard facing, I now have buttery smooth 1st pull & let off.
-
The Following 2 Members Say Thank You to CINDERS For This Useful Post:
-
02-04-2018 07:57 AM
# ADS
Friends and Sponsors
-
Well you're more cultured than me Ron. At least you call the two little bumps on the trigger 'nodes'; I call them ''tXXs'! Mind you, I was dragged up.........
-
The Following 2 Members Say Thank You to Roger Payne For This Useful Post:
-
-
Deceased August 31st, 2020
Without niXXles ''tXXs' would be pointless.
-
The Following 4 Members Say Thank You to englishman_ca For This Useful Post:
-
Legacy Member
Ahahaha that's a laugh.
And cheers Cinders, I have a little rotary tool/mini drill I polish things with, so I can do that easy.
-
-
-
PM
