-
Contributing Member
Real men measure once and cut.
-
The Following 9 Members Say Thank You to Bob Seijas For This Useful Post:
-
07-20-2018 10:28 PM
# ADS
Friends and Sponsors
-
Contributing Member
Wonder who did the mod to the machine!
-
-
-
Legacy Member
Could you give us a idea how it works?
-
-
Contributing Member
Screw the barrel on hand tight and insert the assembly into the machine at the far left. There are three sliding levers to tighten the receiver in the exact proper position. Engage the top slot of the barrel with the key in the opening on the right, the indexing arm will register near the lower tick mark (it's all the way down in the photo). Pull the large lever across the front until the index arm mark points to the top mark, it's done
Real men measure once and cut.
-
Thank You to Bob Seijas For This Useful Post:
-
Advisory Panel
Neat piece, looks like it was still bolted down though. I'd love to see it set up to make the picture clearer. Would make things easier than using the anglemeter I guess...
-
-
Legacy Member
I had a chance to buy one a few years back, in hindsight I should have
-
-
Legacy Member
-
-
Legacy Member
You should do a you-tube video of it in use
-
Thank You to jamie5070 For This Useful Post:
-
Contributing Member
Yeah, if I knew word one about YouTube
Real men measure once and cut.
-
-
Advisory Panel
If you had a look, I know you'd figure it out...but then you'd need the vid. I'd like to watch too.
-