-
FREE MEMBER
NO Posting or PM's Allowed
Remington 513T (US marked) Question
Hi,
I have a US marked Remington 513T .22LR. The barrel wobbles up and down a little, not enough to be a major bother but I'm not used to barrels wobbling on me and I just wanted to check with you guys. I realize that it's a free floating barrel, and you can slide a piece of paper under it - but was wondering if it's normal to have it wiggle a little and if there's a way I need to tighten it. Thanks!
Patrick
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-20-2009 07:25 PM
# ADS
Friends and Sponsors
-
Moderator
(Edged Weapons Forum)
If is wiggling like as in something is loose, is never a good thing. If its is moving because direct pressure is being applied may mean the action needs a little bedding. Have it checked in any event-SDH
-
-
-
Advisory Panel
thats one of the problems with the Remington 500 type bolt action rifles.
they are only held in the stock with one screw.
check to see if the stock is cracked around that area, iv repaired many 513T,s with this issue.
everyone had a cracked stock in the area were the screw goes through the stock.
they dont fit very tight to begin with, so take that in mind.
-
Register To Reply
