How to install selector lever/cutoff

[daveboy]

It's been a long time since I took a Krag down completely. Today, I did just that. Now, I'm having a hard time getting the magazine cut-off back in the rifle. I know it's just a matter of pressing down that plunger and pushing it in. But, there has to be a trick to it because I simply can't hold the plunger in far enough and put pressure on the lever at the same time. Any help?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[butlersrangers]

You start the cut-off's shaft into its hole in the receiver until the detent-pin stops progress. Then use a small screwdriver tip to depress the detent-pin, while advancing the cut-off forward into place. (Kind of the reverse of attached sketch).

It helps if the detent-pin is lubricated and not bound up with ancient dried grease.

Attachment 101183

[daveboy]

You start the cut-off's shaft into its hole in the receiver until the detent-pin stops progress. Then use a small screwdriver tip to depress the detent-pin, while advancing the cut-off forward into place. (Kind of the reverse of attached sketch).

I tried doing that last night. Just got frustrated. I'm gonna give it a go again today. Thanks

[butlersrangers]

Soak your cut-off in some Hoppe's #9, overnight. Press and work the detent-pin, against a piece of hardwood, before trying to install. It is amazing the 'red gunk' that gets pumped out of the assembly, sometimes.