-
Legacy Member
Zf39 low turret mount
Hi all
I have a “ repro” k98k sniper with a low turret mount.
The scope is angled sligthly down forward.
(Distance from tube to bolt body is about 0,6 mm lower
In the front end)
First i think it was an issue with my mount
But looking at pictures of real low turret snipers
It seems to be the same.
Any explanations for this
Jsne
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
11-06-2019 02:05 PM
# ADS
Friends and Sponsors
-
Legacy Member
Hi Jsne,
Have you tried firing it? Both my turret snipers look like the scope is tilted forward but it’s just an illusion and they are level.
Even my SSR looks lower at the front.
https://i.imgur.com/TJZnxI4.png
https://i.imgur.com/HpfQDZk.jpg
-
Thank You to jonh172 For This Useful Post:
-
-
Legacy Member
Hi John
Yes I have fired it many times
No problem at all.
Shot at 200 m post is in the middel.
But I wondered why.
It is allmost level but not complete.
All pictures look the same.
Jsne
-
-
Legacy Member
If the post is off by a bit you can slip the range dial to re-zero it.
Loosen the 3 cap screws and rotate the range disc until it lines up to your distance, tighten screws and done!
-