Need the M1 Garand Trigger Housing and the SA Trigger blueprint

[usabaker]

Does anyone have the Garand d28290-18-SA Trigger Housing and the SA Trigger blueprint or a drawing showing all of the dimensions?

I searched the Forum without luck so far, still working on internet searches.

Thank you in advance.

Bill

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Bob Seijas]

Try Eric Nicolaus: themerc@windstream.net

[Mark in Rochester]

Sent you a link to .jpg of the Drawing - did you receive?

Try this

Google Photos

[usabaker]

D6528290 Sent you a link to .jpg of the Drawing - did you receive?

Hi Mark, I didn't, where did you send it to?

Thank you for the help

Bill

[Mark in Rochester]

Hi Mark, I didn't, where did you send it to?

Thank you for the help

Bill

sent it thru this sight also posted link above

I believe the trigger housing number you are looking for is .515 +0 /-0.010

the dimensions are on sheet 2 of D6502290

[jesse_]

With the ancient D-28290 drawing the number i got was .502-.523".

My dims were from the:

Trigger pin to back of the trigger slot;

Max .710 and Min .690" . This takes into consideration where the front of the slot datums to the trigger pin (.010"+.000-.010")

Hammer pin to the forward surface of the trigger hook engagement slot;

Max 3.205" and Min 3.200"

Tolerance between the hammer and trigger holes of +-.002 on the 1.990" dim.

Please check my math

I'm glad somebody who worked for Winchester took home most of the prints. The latest I have is 1942.

[usabaker]

sent it thru this sight also posted link above

Oh.. the google link didn't work and I never got the other. But thank you for trying I do appreciate it.

---------- Post added at 03:46 PM ---------- Previous post was at 03:41 PM ----------

With the ancient D-28290 drawing the number i got was .502-.523".

I think that's the safety cut out, I think the trigger cut outis .700 - .701"

[usabaker]

Try Eric Nicolaus: themerc@windstream.net

Bob, Thank you but for what information I need Item Name: Rifle, U.S. Cal .30, M1: Diagrams & Pictures Price: $40.00 is kind of outside what I require. All I really need is these dimensions

Attachment 110529

I just thought the drawing was the best way to go since they would be factory dimensions.

[jesse_]

I can pull the drawings, but the dims are datumed off of different features. The answer wont be .455" or anything like that. Its all tolerance stack.

I need to wait till I get off of work

[usabaker]

I can pull the drawings, but the dims are datumed off of different features. The answer wont be .455" or anything like that. Its all tolerance stack. I need to wait till I get off of work

Jesse, no rush thank you for the help.

Bill