-
Legacy Member
L1A1 Armourers tools + safety catch
Wondering as to the value of the below, rarely seen on the market.
Many thanks.
L1Al Armourers tools, Genuine articles in used condition.
Butt removal tool
Gas block reamer
Firing pin removed tool
Gas cylinder nut c spanner
Safety catch, automatic variant for FAL.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
04-22-2021 11:33 AM
# ADS
Friends and Sponsors
-
Legacy Member
Try DS Solutions for a price guide
-
-
-
Legacy Member
Thank you.
Have previously viewed, they only have a butt removal tool, none of the others.
-
-
Legacy Member
I would imagine only nominal values for the others. Not a lot of call for them, especially the gas parts tools
-
-
Legacy Member
Firing pin removal tool??? was that not just the tip of a round? you only need to push out a solid pin,
Could it be the extractor removal tool ( there are a few different types, )
Butt removal tools £30-40 gas plug reamer £20-40 If you need one ( you only need one if you are live firing using the full gas system as the tool is used to remove the burr that is set up in the gas block) by the gas piston hitting the gas plug
the C spanner value depends on any markings is it an original Fn produced? or a UK factory made (marked to Enfield or other) or if its an Armourers made tool, £5- £15 as a collectable
-
-
Legacy Member
Hi Skiprat
Thank you for spotting the senior citizens moment, yes of course I meant an extractor removal tool, doh.
Thank you for the other info. The C scanner is an armourers made tool, we made quite a few of our own tools.
The extractor removal tool is not the U shaped one of which there are many variations.
Thank you again.
-