Remind me before I screw something up

[newcastle]

on No.1 Rifle one must take off the forend BEFORE removing the Buttstock, correct? ...or was that No.4s.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[HOOKED ON HISTORY]

Yes for end first butt second.

On No 1

[newcastle]

thank you

[RobD]

And when I've taken out the stock bolt, I'd grind off the square section at the end so no poor soul screws up the fore end in future.
Wood is getting scarce, and personally I've not known a bolt becoming loose in civilian use... has anyone?

[browningautorifle]

I'd grind off the square section at the end

Agreed, an antiquated manufacturing quirk that's no longer required.

[breakeyp]

A good habit to cultivate is to always remove the forestock first regardless of model.

[Alan de Enfield]

And when I've taken out the stock bolt, I'd grind off the square section at the end so no poor soul screws up the fore end in future.
Wood is getting scarce, and personally I've not known a bolt becoming loose in civilian use... has anyone?

Which was an official modification announced in an EMER, with a note that ...........

"The end bolt should be 1 complete thread inside the butt socket" (below the surface)