Printable View
Picked these up last week :
Apparently made in Spain in the 20's for the No1 Mk3, Rifles.
Rifled "bore" and in calibres
4x6 mm Flobert
4mm Zentralfuer RWS
Never seen inserts for these calibres before.
https://www.milsurps.com/images/impo...5acb94b2-1.jpg
https://www.milsurps.com/images/impo...8a30f633-1.jpg
Interesting Alan. Never seen any exactly like that before, although the principle is the same as with the 303/22 (or is it 22/303?) 'conveyors' used on some of the earlier SMLE trainers. The idea is still alive & kicking as someone recently showed me some new made examples chambered for .32" ACP (I think they were made in the US).
ATB.
Nice find on those inserts.
I once had a German made Erma copy of a PPK that used what appeared to be .32 ACP insert and shot 4mm M20 cartridges.
I had some in .22 for use in a special barrel setup in the .30 cal MG. Looked like a .30 cal round but had the .22 bore. Yes, those are neat...
Saw those too, but didn't bid as I wasn't sure whether they were 'obsolete calibre' or the potential UK FAC implications... They look very nice and a good price I believe!
ATB
Mike
I'm pretty sure they will be section 1 but until I can sort it out for my FAC they are on a RFD 'ticket'Quote:
Originally Posted by Gingercat
The ones you speak of Rog, I never had much luck with, more time consuming than anything else trying to get the empty case out of the adapter plus they don't feed etc, that's when I started downloading my ammo ......Quote:
Originally Posted by Roger Payne
The ones in Alan's pics look well made as they will feed from the mag unlike the adapters for .32 ACP as this is just like a spent case. Lothar Walther also make adapters (sub cal adapters) and I,m sure they use a similar round for some of the ones they make for pistol as Al Diehl mentions in his post.
Yes, I was briefly interested in the 32 ACP jobs as using them would have allowed me to shoot Lee Enfields at Wedgenock where full house rifle rounds are verboten. I'm not into lever actions or other pistol calibre carbines so it seemed like it might be a way to go. But in the end I just decided to keep on using my little 22LR CAR15 fun gun instead.
ATB
There are some .303 sub cal units been made locally for 7.62 x 25
Works like stink and cheap shooting.
Here is another sub cal unit in .22
This one is for the Vickers.......
Attachment 52393
Attachment 52394Attachment 52395Attachment 52396
Some testing done at pistol range distances with some early rifles, both the 32 ACP and 32 S&W short can be used. The steel cartridge adopter appears to workout very well in the different rifles
I keep one (a .32 ACP adapter) in an empty oiler in the butt of my LB No4. The rifle is surprisingly accurate with .32 ACP.Quote:
Originally Posted by RCS
I had one for 7.62x25 and nearly ruined my rifle. It swelled up so bad that I almost couldn't get it out. In fact, I had to tap it , turn a bolt into it and then carefully drive it out with a steel rod. A standard stuck case remover was a fail in getting this thing out.
Al
It would be interesting to ream out the 32ACP/32 S&W short to 32 S&W long in the cartridge adopter, a very accurate cartridge and easy to reload.