-
Advisory Panel
Has anyone heard these before??????
"Many of the rifles went to India, the chambers are slightly "out-of-round" to drain water out of the bore."
"The only real problem I have ever run into is that the No.IV's that have not been FTR'd, you may twist the receiver trying to remove the barrel."
"The best thing to do is to ascertain what your problem really is. Take a sized casing or a loaded round (at the range), and load from the magazine. As you close the bolt, you must feel resistance at 2:30-3:00 on the bolt handle as you close the bolt. If you don't you need to get a new longer bolt body from Springfield Sporters, or pay $$$ for a longer bolt head. Make sure you have the seller measure the bolt head befor you by it. A marking on the bolt head means nothing these days, if he won't, run away."
If you DO feel resistance, than your chamber has been opened up and elongated by the Indian Army. There is nothing you can do short of putting a replacement barrel on your rifle. If your rifle is not FTR marked, removing the barrel can be a real problem.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
11-08-2011 05:47 AM
# ADS
Friends and Sponsors
-
So what's the point here? Are we putting up "furfies" we often hear people say, or saying something about ex indian rifles?
-
-
-
Advisory Panel
just statements from a "respected" source... furfies...yes
-
-
Some will come to me, I seem to forget them really quickly of late.
-
-
Legacy Member
"The best thing to do is to ascertain what your problem really is. Take a sized casing or a loaded round (at the range), and load from the magazine. As you close the bolt, you must feel resistance at 2:30-3:00 on the bolt handle as you close the bolt. If you don't you need to get a new longer bolt body from Springfield Sporters, or pay $$$ for a longer bolt head. Make sure you have the seller measure the bolt head befor you by it. A marking on the bolt head means nothing these days, if he won't, run away."
If you DO feel resistance, than your chamber has been opened up and elongated by the Indian Army. There is nothing you can do short of putting a replacement barrel on your rifle. If your rifle is not FTR marked, removing the barrel can be a real problem.
So...if I feel resistance, I have a problem. If I don't feel resistance, I have an even bigger problem.
I'd better go check my rifles, this could be serious...
-
-
Legacy Member
Son - You didn't find this information on April 1st did you ?
Mine are not the best, but they are not too bad. I can think of lots of Enfields I'd rather have but instead of constantly striving for more, sometimes it's good to be satisfied with what one has...
-
Thank You to Alan de Enfield For This Useful Post:
-
Legacy Member
I saw yesterday on another forum. I wish it was an April fools joke.
-
-
Advisory Panel
Sounds like a crock of s--t to me. I've had many former Indian rifles through here and have never encountered anything even close. That kind of modification would never be approved in any serious military service and the Indians do most everything to MoD spec anyhow.
-
Thank You to Brian Dick For This Useful Post:
-
Legacy Member
Originally Posted by
Alan de Enfield
Son - You didn't find this information on April 1st did you ?
Grab your No5 "truck gun" shoot your way though all the Zombies till you reach the top right hand corner, all will be revealed.
-
-
I haven't heard of them before................. I've been an Armourer for one or two - or maybe three years. Should I have heard?
-
Thank You to Peter Laidler For This Useful Post: