Attachment 35677After obtaining a new forend form the nice folks at BDLicon and reading Mr Laidlericon's article on forend fitting many times I jumped in head first this week end on my debubba project. Following the instructions I marked, fitted,trimmed the draws to a very snug fit. I thought that was going to be the hard part until I attempted to fit the nose piece. Followed the same mark,fit ,trim procedure to obtain fitment to the forend.The problen arose when trying to fit the upper hand guard.
There is insufficent clearence for the metal cap on the end of the upper handguard to tuck under the nose piece.Thinking there might be some variance in tolerances I tried three diffrent nose pieces with the same result.
Here is the question. Is there a proper procedure for fitting the nose piece?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.