After many years of dreaming I finally got my Martini Henry, an Afghan bring back with some internal "home made" parts. One of the last parts Ihave to replace is the Tumbler.
I just received one in the mail & it is strange in that the lower arm (which contacts the trigger) has a seperate piece cut into & protruding down from the arm very slightly. Hopefully a picture is attached. Does anyone have any idea of what this tumbler is from? Some kind of later development perhaps?

Ideas or suggestions would be appreciated, also any idea of where to get the correct tumbler.
Peter (in Burlington, Ont.)

Photos can be seen at: Martini parts 005 on Flickr - Photo Sharing!


Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.