-
FREE MEMBER
NO Posting or PM's Allowed
interesting thread, I have the same question
-
07-13-2018 03:58 PM
# ADS
Friends and Sponsors
-
Legacy Member
Does anyone know how to remove the screw and slide from the leaves on the mk1 micrometer sight???
-
-
-
Legacy Member
Use a small punch to drive out the pin at the top of slide on the righthand side. It may be hard to drive out. I needed to use a little heat to get mine out. Then you can unthread the screw and remove it. Be careful not to lose the detent pin and spring captured on the other side. Then the cursor just slides off.
-
Thank You to Bigwagon For This Useful Post:
-
Legacy Member
Wow thank you for such a quick response! What do you mean by heat
-
-
Legacy Member
My BSA mk1 sight screw has a B on the top of it. Wouldnt a Fazakerley screw have an F on it or would there be no letter?
-
-
Legacy Member
One of the senior contributors to this forum who knows a thing or two about working on No4's has suggested a few times, to take your sight apart in a plastic bag - so u dont loose the minute and easily lost bits - advice worth following
-
Thank You to brnom2 For This Useful Post:
-
Yes, Faz screws bear a letter 'F' on the top, although I've seen some that are unmarked, so no idea who made those.
-
-
Legacy Member
some of the DOW made MK I rear sights are unmarked.
-
Thank You to Frederick303 For This Useful Post:
-
Legacy Member
As for the mags, Ive heard conflicting reports on whether they came with the serial number electropenciled along the bottom of the mag. Did they all come with the serial number or would an unnumbered mag also be correct?
-
-
Legacy Member
Anyone know how to assemble one of these Mk1 sights??? I cant find instructions anywhere
-