-
FREE MEMBER
NO Posting or PM's Allowed
M1 Garand Gas Plug - Thread Pitch, Size, Specs?
Does anybody know what are the M1
Garand Gas Plug specifications? Inner, outer diameter...thread pitch, etc.? Is it a standard size? Thank you.
George
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
07-24-2009 02:02 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
The one dimension I'm familiar with is the length at .700 max.
-
-
Contributing Member
Page 128 of Rifle, U.S. .30 , M1 Diagrams & Pictures by Eric Nicolaus
In Zone B-3 of Dwg 7310083
9/16 - 32 NS - SPL
Major dia .5625-.0060
pitch dia .5422 (-0.0030)spl
Minor dia .5242 Max
It is also the same thread as the end of an m1 barrel
He is no fool who gives what he cannot keep to gain that which he cannot lose
There are no great men, only great challenges that ordinary men are forced by circumstances to meet.
-
-
Legacy Member
9/16 - 32 UN . You can order the tap and die from any good supply company.
I think I paid around $25.00 for both. Steve
-
-
FREE MEMBER
NO Posting or PM's Allowed
If you are in that deep, I suggest getting the Nicolaus book or Kuhnhausen's book.
-
Legacy Member
There are manuals and specs galore in the threads at the top of the M1 page. including complete blue prints.
-
-
FREE MEMBER
NO Posting or PM's Allowed
Gas Plug Repo?
Seems like you guys know your stuff. What is the best way to tell if a single slot plug is a repo or authentic?
Register To Reply
