frustration!

[srk3006]

trying to put new bayonet lug on rifle and the cross screw will NOT line up! what is this newbie doing wrong? the old one did'nt either. when off the rifle screws in fine, but will not start on rifle..help!................

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[mtbikerwvu]

Slightly enlarge the hole in the stock to allow the retaining bolt to move a little more freely and find the threaded portion in a better position.

[Rick the Librarian]

Did you try tapping the front of the upper band with a block of wood and a hammer? Sometimes due to swelling in the wood, the upper band doesn't line up properly.

[Chuckindenver]

i suspect this is a 1903A3, since they are a bear to get done.
loosen the stacking band, and then line the hole up and try it.
over sizing the hole works, but should be done as a last resort.

[emmagee1917]

Try putting on a bayonet and use it for leverage . As was said , you've got to align it juuussssst right.
Chris

[srk3006]

Success! thanx for hints, cleaned up stock hole slowly and..poof! it went thru. thanx to all, great forum for info!............steve