-
FREE MEMBER
NO Posting or PM's Allowed
Type II Handguard with "A" stamped on Underside
I have a very nice 2 rivet early handguard with the wide sight groove but the only stamping I can find on it is an "A" stamped in the barrel groove on the underside about 2 inches from the metal insert that the rivets are in. Any idea on the manufacturer? It has the cutout for the op rod.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by Milwroad; 07-24-2011 at 12:04 PM.
-
07-24-2011 12:01 PM
# ADS
Friends and Sponsors
-
Legacy Member
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Here are 2 pics. Sight groove is 3/4 inch wide.
-
Legacy Member
No it does not have the Winchester circles on the cutout. So it may not be Winchester. I have seen that A before, just don't recall.
-