Hello. I am new here and have enjoyed reading over the information on your forum.

I'm putting together a new Boyd stock for a Garandicon I purchased that did not have a stock. This is my first time putting the metal on to a new stock because my other Garands have always come with stocks.

When I was going to attached the Rear Handguard Retaining Clip I noticed the ends of it were not bent exactly the same. Then I looked closer at the handguard and noticed one side is thinner than the other where the clip bends over the wood. Below is a picture of the retaining clip.

My question is which way does the clip go on or does it matter? Thanks for your help.


Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.