I have a Lee Enfield firing pin tool, but it doesn't seem to work...does the No 4 and the No 1 use the same tool? Today I removed the screw that retains the firing pin on a No 4 Mk 2 bolt, then inserted the tool into the bolt over the firing pin. The two prongs went way down in but did not solidly engage with anything inside despite rotating it around and pushing down hard with it.
The prongs are a little bent and burred...perhaps the tool is NFG. I'd think you need a really solid engagement with the two prongs into whatever...is there a reasonably priced tool that works?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.