Has anybody ever had trouble primeing TZZ (IMI) 223 brass ? I am working with some and useing RCBS hand primeing tool several primers tilt to a side and get jammed up I have to take tool apart to clear it. I have removed Mil. primer pocket crimp and checked several peices of brass again. I had the same problem with some Federal 223 brass but I could look at it and see primer pockets off center lay it on table and roll it I could see alot of run out so they are in the scrap bucket.
IMI usually makes good stuff I hope I don't have to scrap it.
I thought it may be my primeing tool but I have no trouble with LC or Win. guess I'll stick with what works for now. Thanks
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.