-
Legacy Member
03A3 Won't Feed, Help please.
I've got an all original 1943 Remington 1903A3 that is having a problem feeding the next round. It's almost as if the bolt is not going back far enough to pick it up, but the bolt seems to be retracting as far as it should. Any ideas?
P.S. Is this how the follower is supposed to be installed? I don't know if this could be the issue.
Attachment 56565
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
09-27-2014 11:43 PM
# ADS
Friends and Sponsors
-
Contributing Member
Opposite the bolt handle is a tab it should be up in the on position. The off position is for one cartridge at a time. Center is to remove the bolt.
-
Thank You to 25-5 For This Useful Post:
-
-
Advisory Panel
That should take care of it...
-
-
Legacy Member
Goes to show how little I know about bolt action rifles! My specialty lies in the Garands and Carbines. I do remember the switch being off, so after reading yalls posts, I'm sure that's what it is. Thanks a ton guys and I shall report back!
-
Thank You to garrettbragg12 For This Useful Post:
-
Advisory Panel
as answered in another forum....flip the cut off ON...that turns the magazine on..
-