-
FREE MEMBER
NO Posting or PM's Allowed
Brass question
I have a large quantity of fired IVI 7.62X51 blank cartridges. Would it be feasible to cut the crimped 'bullet' tip off and trim to length to create regular brass for reloading?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
10-25-2014 12:36 AM
# ADS
Friends and Sponsors
-
Advisory Panel
IVI 7.62 live brass is very good and long lasting brass. The blank is a bit different though. It starts the same as ball brass but ends differently. I don't think it's got quite the same inside diameter at the neck as ball brass. I've shot thousands of it but we never even considered using it for anything...I wouldn't...
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Tried it, didn't work. Waste of time.
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks for the input. I will just link them up for decoration then.
-
Legacy Member
Many times the brass used for blanks is brass that was rejected for normal ammo. It's in general a good idea not to used blank brass for reloading.
-