-
Legacy Member
Springfield Bolts
I have a bolt that has a faint "P" stamped on the underside of the root. I tried to make a Remington "R" out of it but I'm quite sure it's a "P". The safety lug is contoured in manufacture but rather crudely compared to other bolts. I also have a couple of bolts made by Brown & Sharpe in heavy protective paper in their box. No safety lug contours on those bolts. (If these bolts were for Japanese
rifles, we would call them "last-ditch".) I also have a Smith Corona bolt box with three SC bolts in their wrappers--I swapped one of the original 4 into a friends rifle.
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
01-13-2015 09:45 PM
# ADS
Friends and Sponsors
-
1. is the bolt handle "swept" or straight?
2. pictures would help
People sleep peaceably in their beds at night only because rough men stand ready to do violence on their behalf.
--George Orwell
-
-
-
Legacy Member
Swept. Under bright light with a magnifying glass, it still looks like a capital P, not R. I can find no other markings on it. Machining is a bit rough. It has the large gas hole that would line up with hole in the left side of the receiver ring in A3's. There are no wear marks to indicate it has ever been used. It's apparently a war-time replacement bolt made by an outside contractor like Bonney Forge, etc.
-
PM
