+ Reply to Thread
Page 1 of 3 1 2 3 LastLast
Results 1 to 10 of 24

Thread: Type 99 "Basement Find"...

Click here to increase the font size Click here to reduce the font size

Hybrid View

  1. #1
    Legacy Member 728shooter's Avatar
    Join Date
    Dec 2014
    Last On
    03-06-2024 @ 04:39 PM
    Location
    South Florida
    Posts
    74
    Local Date
    05-03-2024
    Local Time
    12:21 PM

    Type 99 "Basement Find"...

    Wife's aunt in North Carolina found some old rifle parts in a basement she was cleaning out for a friend, said I could have them. Turned out to be an Arisakaicon 99 barrel, receiver and stock, which had rust and looked like it had been there for 50+ years, most other parts missing. Started to clean it up and restore it, took 6 months to find all the missing parts on the Internet. This is how it turned out.....

    Attachment 60667Attachment 60681Attachment 60680Attachment 60679Attachment 60678Attachment 60677Attachment 60676Attachment 60675Attachment 60674Attachment 60673Attachment 60672Attachment 60671Attachment 60670Attachment 60669Attachment 60668Attachment 60682
    Information
    Warning: This is a relatively older thread
    This discussion is older than 360 days. Some information contained in it may no longer be current.


  2. #2
    Advisory Panel

    jmoore's Avatar
    Join Date
    Mar 2009
    Last On
    06-09-2023 @ 04:20 AM
    Location
    US of A
    Posts
    7,066
    Local Date
    05-03-2024
    Local Time
    01:21 PM
    A worthy project!

  3. Avoid Ads - Become a Contributing Member - Click HERE
  4. #3
    Legacy Member AZPhil's Avatar
    Join Date
    Dec 2007
    Last On
    02-23-2021 @ 12:03 AM
    Location
    Yuma,AZ
    Posts
    370
    Local Date
    05-03-2024
    Local Time
    01:21 PM
    Great job saving a piece of history from the rust pile!!!
    Semper Fi
    Phil

  5. #4
    Advisory Panel browningautorifle's Avatar
    Join Date
    Jul 2008
    Last On
    Today @ 10:56 AM
    Location
    Victoria BC
    Posts
    29,959
    Real Name
    Jim
    Local Date
    05-03-2024
    Local Time
    10:21 AM
    Very nice, I better go look in the basement now...
    Regards, Jim

  6. #5
    Legacy Member c1a1's Avatar
    Join Date
    Oct 2006
    Last On
    11-12-2023 @ 08:09 PM
    Posts
    13
    Local Date
    05-03-2024
    Local Time
    12:21 PM
    Nice restoration. Is the bore in good shape?

  7. #6
    Legacy Member HOOKED ON HISTORY's Avatar
    Join Date
    Mar 2011
    Last On
    Yesterday @ 06:16 PM
    Location
    MS/USA
    Posts
    4,001
    Local Date
    05-03-2024
    Local Time
    12:21 PM
    Fine work!

  8. #7
    Contributing Member Aragorn243's Avatar
    Join Date
    Apr 2009
    Last On
    Today @ 08:56 AM
    Location
    Pennsylvania, United States
    Posts
    7,031
    Real Name
    Steve
    Local Date
    05-03-2024
    Local Time
    01:21 PM
    Very nice. Bore should be chromed so should be fine.

  9. #8
    Legacy Member Salt Flat's Avatar
    Join Date
    Nov 2011
    Last On
    Today @ 09:48 AM
    Location
    USA
    Posts
    760
    Local Date
    05-03-2024
    Local Time
    10:21 AM
    728, Sometimes you just get lucky! Also your restoration work is impressive. Looks to be a First series Nagoya. Salt Flat
    Last edited by Salt Flat; 03-04-2015 at 07:58 PM.

  10. Thank You to Salt Flat For This Useful Post:


  11. #9
    Legacy Member 728shooter's Avatar
    Join Date
    Dec 2014
    Last On
    03-06-2024 @ 04:39 PM
    Location
    South Florida
    Posts
    74
    Local Date
    05-03-2024
    Local Time
    12:21 PM
    Thread Starter
    When I first saw the barrel covered in rust, I didn't think there was much hope for it. However, it all turned out to be just a light surface rust that surprisingly, cleaned up rather nicely with some light oil and a fine wire wheel, and left most of the bluing intact and no pitting whatsoever. Swabbed the bore out a few times to get the dust & crud out and found that the chromed bore was near perfect. All the numbers matched on the parts that were there and the stock (not perfect but in decent shape) still had the original cleaning rod in it. All I had to work with was the barrel/receiver with the aircraft sights and both bands still attached, the complete bolt, and the stock. Everything else was stripped off or missing; all screws, nose cap, hand-guard, trigger guard with mag. and follower, butt plate, rear swivel, tang and receiver screws.

    I did some research on the serial number and it does appear to be a 1st series Nagoya arsenal rifle. (Salt Flat, you got a good eye!) My guess is it's probably late '39 or early '40's production. No import marks anywhere so I am assuming it was a war bring-back souvenir. Am going to try to find out who lived in the house and who may have owned it or brought it back. Probably put more time & money into it than she's worth now but I hate to see a piece of history like this go into the trash.

    Now looking for some 7.7 Jap ammo to try it out at the range but the only stuff I can find at my local shows is $2.00 a round (which I refuse to pay). Will keep all posted when I take her "out for a spin".....

    Thanks to all for your comments & support! --728shooter

  12. Thank You to 728shooter For This Useful Post:


  13. #10
    Contributing Member CINDERS's Avatar
    Join Date
    Nov 2009
    Last On
    Today @ 11:55 AM
    Location
    South West Western Australia
    Posts
    7,767
    Real Name
    CINDERS
    Local Date
    05-04-2024
    Local Time
    01:21 AM
    I have heard the Arisakaicon 7.7 can fire the Britishicon 303 cartridge but not the other way around the Japanese cartridge case being longer so would not chamber in the Lee Enfield from what I also recall the 7.7 round is semi rimmed

+ Reply to Thread
Page 1 of 3 1 2 3 LastLast

Similar Threads

  1. PPU/Privi 174gr FMJ "Mk VII"-type ammo? Experiences with Bren??
    By TactAdv in forum The Bren LMG (Light Machine Gun)
    Replies: 9
    Last Post: 07-19-2014, 12:22 PM
  2. Latest Cabelas' find - Finnish M38 "Terni" carcano with stock disk
    By gunhorde in forum Milsurps General Discussion Forum
    Replies: 1
    Last Post: 12-03-2013, 11:33 AM
  3. SAVAGE "S" in details, "ILCO butt trap", "P" on bayonet stud,what co. was ILCO?
    By Garandrew in forum The Lee Enfield Knowledge Library Collectors Forum
    Replies: 3
    Last Post: 11-15-2010, 07:48 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts