I'm fixing up a pretty trashed type 38 arisaka stock at the moment, has had a couple of sections rot out from oil soak etc that I've had to cut out and replace. I was thinking about acraglasing a threaded rod down the whole length of the cleaning rod channel to give it support. Would this act as a hammer over time though with recoil, smacking the receiver apart or if its glassed in would it be ok?? (I did think of using a wooden dowel instead but its probably a bit flimsy) thanks
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.