Folks,

I have just started having some problems with an Inland.

It has worked in the past.

It was not always cycling the action, with round not properly chambered, and in addition, it was not always firing even after a round was manually chambered.

I thought initially it might be a mag problem, (my nephew and I were using a couple of 30 rounders in our D-Day celebration).

I am fortunate enough to have a Winchester carbine as well, so we switched mags and the Winnie worked flawlessly. I even took a round out of the Inland that did not fire and had him load it in the Winchester and it fired straight away.

I am afraid it is a problem with the firing pin, as the round I had him fire in the Winnie had no firing pin mark. Then, last night at my local shop someone told my it might be a headspacing problem.

In the past I have found answers on this forum, and again look for help from wiser heads than mine.

(The ammo was Wolf and some Seller & Belloit more probs w/ the Wolf.)
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.