-
Legacy Member
Savage MK1 No.4
Another dumb question...
Now that the stock is refinished, how do I get the bands on? Seems like I'll need to bend them open a bit, but then it'll be hard to get the screws aligned and started. Any secrets to make it easier?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
02-01-2010 09:23 AM
# ADS
Friends and Sponsors
-
Hi .. 
Perhaps download a complete set of manuals for the Lee Enfield, which includes operating and armourer's maintenance instructions.
The manuals may be found in the Technical Articles for Milsurp Collectors and Re-loaders (click here)
2002 No.4 (All Marks) .303 Rifle Manuals (click here)
Complete Set includes:
- 2002 No.4 (All Marks) .303 Rifle Data Summary
- 2002 No.4 (All Marks) .303 Rifle Parts Identification List
- 2002 No.4 (All Marks) .303 Rifle Operating Instructions
- 2002 No.4 (All Marks) .303 Rifle Equipment Description
- 2002 No.4 (All Marks) .303 Rifle Maintenance Instructions
1991 No.4 (All Marks) .303 Rifle Manuals (click here)
Complete Set includes:
- 1991 No.4 (All Marks) .303 Rifle Operating Instructions
- 1991 No.4 (All Marks) .303 Rifle Maintenance Instructions
Note: The difference between the 1991 set of No.4 Manuals and 2002 No.4 (All Marks) .303 Rifle Manuals, is that the 1991 manual contains armourer's information on how to properly "bed" the No.4 rifle, whereas the newer 2002 manual does not.
Hope this helps... 
Regards,
Badger
-
-
-
Take the foresight protector off the foresight block. THEN install bands! (Sometimes its easier to install the rear one last, allowing the front band to be angled on w/o the front handguard in the way.)
Last edited by jmoore; 02-01-2010 at 10:27 AM.
-