-
Legacy Member
Enforcer Safety
Does anybody have a spare Enforcer safety for sale or trade? Must be original design. Any question on availability and cost? Ron
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-17-2010 09:53 PM
# ADS
Friends and Sponsors
-
Advisory Panel
They're around, mostly on ex-target No4s or in the hands of ex-DCRA shooters/gunsmiths. But then you probably know that. Bob Barwise in NS maybe?
-
-
-
Legacy Member
Originally Posted by
Surpmil
They're around, mostly on ex-target No4s or in the hands of ex-DCRA shooters/gunsmiths. But then you probably know that. Bob Barwise in NS maybe?
Just wondering why an Enforcer safety would end up on a target No4 or a DCRA conversion ?
The 'special' safety was only needed to replace the 'standard' safety because the mounting bracket on the PH5E/4 moved the sight rearwards ( about 3/4" compared with a PH5C or AJP 4/47) which meant it 'fouled' on the original safety.
I cannot see why anyone would change the safety from the original on a 'normal' target rifle, where either a PH5C or a scope would be fitted.
Mine are not the best, but they are not too bad. I can think of lots of Enfields I'd rather have but instead of constantly striving for more, sometimes it's good to be satisfied with what one has...
-
-
Legacy Member
I've never seen one on anything but an Enforcer due to the Parker Hale 5E mounting configuration. Would most likely come from a tear down. Realize that there weren't many out there in the first place. EFD were looking at reproducing these however I've been told it's not an immediate project. If anybody has a genuine one pls let me know.
-
-
Advisory Panel
Must have been in a hurry: for some reason I thought he was asking for a spare Enforcer barrel.
Last edited by Surpmil; 03-23-2010 at 04:51 AM.
Reason: typo
-
PM
