-
FREE MEMBER
NO Posting or PM's Allowed
Irwin Pedersen New and Old, to me
-
12-03-2011 04:03 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Nice to find an IP in any condition. Based on the above photos, IMHO the flip sights on both appear suspect. I like the barrel band on the Bavarian, but not your older IP. As to the IP acceptance stamp, would have to defer to someone who may have one. Perhaps a picture of the entire stock and slingwell markings would also be helpful.
-
-
Senior Moderator
(Milsurp Forums)
Ditto
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
Green with envy here! Please post some photos of both of them when you have time so we can live a little vicariously.
-
-
The faint stock marking on the old one is S'G' - right? I can see differences in those rear sights that may, or may not be OK. The left side marking on my rear sight differs a bit from yours, and my sight base is a B-IP. - but who knows if they were all stamped exactly the same originally? My band welds are faint like your new one, but the "UP" on my swivel looks slightly different - it might be because of the camera angle on the picture I'm looking at of my sight - I'll check the gun in the morning. The Bavarian sure has a lot of gap between the band and the swivel compared to the old one - mine is about like the old one. I wonder if the difference is in the wood or the bands? My gun isn't an IP, just an early S'G'. - Bob
Last edited by USGI; 12-04-2011 at 01:28 AM.
Reason: to fix my spelling
-
-
DECEASED
Be very suspicious ! Will try and find my stock pics. Mike.
-
Thank You to Mikey51 For This Useful Post:
-
DECEASED
Right hand side of stock is a fraud. What did you find in slingwell ? Mike.
-
-
Legacy Member
On the IP marked stock where are the acceptence stamps located ( picture of the whole stock would also be nice ) and what is the serial number on your new carbine?
-
-
Legacy Member
Noticed the milling marks on the two sights are differant. First one they are horizontal, second one verticle.
The second band has some pretty deep welds. JMHO.....Frank
-
-
The IP stock , Oval or I cut oiler slot?
Does it have a circled P proof on the bottom of the pistol grip?
TIA,
Charlie-painter777
-
Thank You to painter777 For This Useful Post: