Picked up an Enfield No.2 MK I revolver at gun show last weekend. Got it cheap due to several problems. What I thought would be simplest seems to be most difficult is the firing pin or hammer nose missing from it. I am down to considering ordering the "Hammer Point Gauge" from Numrich and fabricating my own. However I can't even find a how to on using it.

Any suggestions of how to use the gauge or a part supplier that might have the firing pin available?

Thank you so much for your help,

Tom W.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.