-
Legacy Member
Colt New Service in 44 S&W question on the markings
I acquired this Colt New Service long ago and beside the refinish and rubber target grips... there is several markings, crossed flags, a star and possibly a Broad Arrow on the frame by the hammer. I have a SW MP Victory with the crossed flags and a broad arrow and was told these were British
Lend Lease marks. I always intended to shot this pistol but never did, hence its nice condition. Any information on these marks is greatly appreciated. As a note, I wanted to have a big shinny revolver to bring to the range, and I had recently returned my Chrome Colt Python to its original owner, by brother.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
Thank You to Cheese Noodles For This Useful Post:
-
02-20-2020 12:03 AM
# ADS
Friends and Sponsors
-
-
-
-
-
-
Advisory Panel
Nice 555 mirror polish job. It takes lots of time and care to get that one right without obliterating markings completely. They have been lightened though, look at the rampant colt. No, that's an aftermarket job not factory.
-
Thank You to browningautorifle For This Useful Post:
-
Legacy Member

Originally Posted by
Lee Enfield
Your New Service was built as a .455 in the 1914-16 period.
The barrel is from the end of production (mid 1930's to early 1940's).
Very interesting, I knew it was far from original..aka Bubba Special even if a well done. How did you know it was built in .455 and had a different barrel? ...and only from 3 pictures... Thank you for the information.
-
-
Advisory Panel

Originally Posted by
Cheese Noodles
Very interesting, I knew it was far from original..aka Bubba Special even if a well done. How did you know it was built in .455 and had a different barrel? ...and only from 3 pictures... Thank you for the information.
.455 because of the British
acceptance markings.
If you remove the Grips, there should be a capital "E" stamped on the frame.
Post WW1 barrel due to the re-inforce against the frame (1919 and later).
1929-1941 barrel due to front sight having a step in the thickness.
I have a few New Services...
Last edited by Lee Enfield; 02-20-2020 at 09:10 PM.
-