LEC restoration help plz

[tatou]

Hi guys,
i would need the help and collective knowledge of the community to restore a LEC i've found a few months ago.
It came to me as a barreled action. Missing the butt stock and the fore end chopped.
Of course no handguard or nose cap too.
Anyhow i managed to track down almost everything needed, i'll fabricate the handguard and do a graft on the cut fore end.

Not having one to compare side by side wont make it easy but i should be able to turn something acceptable.
Now what i would need help with is at least one measurement.
I would need to know how much the barrel sticks out (or protrudes) from the nose cap.
With this i should be able to mockup up things and go from there.
Any and all help/information is greatly appreciated in advance.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[smle addict]

Pulled an LEC Mk I out of the safe, and it looks like the barrel extends just over 1/4 of an inch past the nose cap. I also used a meter tape-measure, and I counted 7mm of barrel protrusion.

Good luck with the resto!

[tatou]

Once again thank you for the help… just what i needed.
It wont be as nice as yours but for a first one it will be good enough.
I also have a NZ one to do and either another LEC or a RIC too… not sure which model the 3rd one was, it's been butchered too much. Have to do more research on it to figure it out.

Pulled an LEC Mk I out of the safe, and it looks like the barrel extends just over 1/4 of an inch past the nose cap. I also used a meter tape-measure, and I counted 7mm of barrel protrusion.

Good luck with the resto!

[tatou]

Here's what i'm starting with...

[22SqnRAE]

Plenty of scope for imagination and outcome there!

[Surpmil]

I have a forend here I can send you photos of, and few measurements if you need them.

[tatou]

Well since i only have a twisted imagination i'll just hope the outcome is good

Plenty of scope for imagination and outcome there!

---------- Post added at 05:10 PM ---------- Previous post was at 05:07 PM ----------

Thank very much… i'll take any help i can. The more informations and pictures i have on hand the ''easier'' it will be (if there is such a thing as easy when doing this)
Should i send you my personal email in PM ?

I have a forend here I can send you photos of, and few measurements if you need them.

[tatou]

Getting slowly there there
Attachment 106895

Pulled an LEC Mk I out of the safe, and it looks like the barrel extends just over 1/4 of an inch past the nose cap. I also used a meter tape-measure, and I counted 7mm of barrel protrusion.

Good luck with the resto!

[husk]

Getting slowly there there
Attachment 106895

Well done!

[browningautorifle]

Getting slowly there

Looking very good, very nice.