-
Contributing Member
1910 Ross with Winchester A5 Scope
Close up pictures of scope mounting, if you are building a replica, would be appreciated,
AGB-1
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
09-03-2020 05:28 AM
# ADS
Friends and Sponsors
-
Advisory Panel
This seems to be a long-standing interest of yours? I don't think you are going to find any such photos, but there isn't really any need for them: a standard 3/8 Winchester/Lyman dovetail block at the rear, and the same at the front with a "flat bar" extension added, or a dovetail block machined with such a riser as one piece. Screw and solder down and there you are. Of course if you want the graduations on the adjustments to have their full range of travel, you'll need to collimate the bases and rings with the appropriate degree of declination. If you buy the reprint of the factory brochure on the A5 it gives more details.
If you want a tip on how to collimate the rings to the bore, my advice would be to pick up a surplus bore sight scope and adapt that into the rings with suitable spacers.
Last edited by Surpmil; 09-12-2020 at 05:37 PM.
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same. 
-
-
Register To Reply
