Search:

Trust me, I know. I already have a sore spot in my stomach, just thinking about it. I'll post the results when I get it finished. Thanks everyone!

Thanks for the input. I have tried the chock both ways...both right and wrong. When I put the chock into place, the flat side will not fit properly when the angle side fits and vice versa. I...

Recently bought a Fulton's scope base and it is not fitting properly. I figure that I'd ask here first before I started smithing on it.
Specifically, it is the piece that fits into the stripper...

Here are a couple of British companies that make scope bases for the No4. Any idea of their reliability/stability? Recommendations?
http://www.fultonsofbisley.com,www.armalon.com

Can someone tell me if these pads look accurate for a No32 scope mount?
Pads 4 Lee Enfield British 303 No 4 Sniper Scope Mount - eBay (item 150472088077 end time Aug-24-10 14:10:53 PDT)

As I...

Great thanks!
Hmmm...might need to clear out a space in the safe...

Can anyone look at this site and see if the wrap is 'arsenal' or not?
http://www.auctionarms.com/search/displayitem.cfm?itemnum=9821579&oh=216543

Thanks.

Check out this website:
Lawrance Ordnance - British No.32 Mk.I Scope (4402)

Take a look at this site -

Lawrance Ordnance - British No.32 Mk.I Scope (4402)

If the stock is off the gun, GENTLY heating (borrow the wife's hairdryer) and rubbing down with a rag will help. Heating will open the pores of the wood and turn the polish to a liquid...I wiped...

Please do! I would really like to get this project going again...it is on hold until I get the screws and the nerve!
What type did you get?

I am trying to build the same thing...but more for the aesthetics than the ugly commercial mount that they sell.
I found cheek pieces and reproduction mounts on ebay. I have bought a cheek piece...

I have a Australian 2d pattern and it does have pin in it. Based on what I have seen here, I might just forgo replacing the pin and leave well enough alone!
Thanks all...learn something new every...

Speaking of scope mounts, I have a No4 and saw a repro scope mount on ebay and Gunbroker. It says that it is threaded to fit in the existing holes, but not sure which holes they are using. Not...

Thanks.
I will do that then. Thanks for the assistance!

The follower is not making contact with the pin at all...

The follower is not making contact with the pin at all...

The pin is there. There is a spring inside of it, but it actually pushes the whole rod 'down'.
It is Australian with the sand cuts...

I've got a L1A1 and would like the bolt hold open pin to activate on an empty magazine. I have taken the pin out and there is a spring already in there, but it does not hold the bolt open. I have a...