Is that a replacement barrel? The muzzle looks very much like what is seen on replacement barrels like Sedgley and High Standard.
Type: Posts; User: gjungle56; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)
Is that a replacement barrel? The muzzle looks very much like what is seen on replacement barrels like Sedgley and High Standard.
There doesn't appear to be enough digits in ser no.
In addition to my other post, 3/16 is about what I strive for provided the barrel and receiver contact for all 360 degrees. Its surprising how many just bear on one side.
Hi
A wrap or 2 of paper around the barrel can do wonders for stopping slippage. I usually true the barrel shoulder but unless you've made all the tooling it may be difficult to do accurately. A...
Was at the range a few days ago and the fellow next to me was shooting his .45. He left without picking up his brass and I picked up a few. Sure enough, the were sm. primer Federals. Upon closer...
I reloaded some (see post below) and had primer leakages. The only thing I can figure is that the case heads are" hollow" from rim to center where primer sits. I'm guessing that upon firing, the...
What receiver are you using? The Izzy barrel has an odd thread.
The bottom of the receiver looks irregular, is it a recovered drill rifle?
George
Carefully (without overheating ) shorten your 1/16 punch to just what is needed to push pin out and you'll be able to move the stubborn pin
...
I happened to end up with some small primer 45 brass and decided to load up some. I shot a few and picked up the cases to check for anything out of the ordinary. I was surprised to see sooty primers...
It appears to me that your oprod has dismounted. Put it back in the track and see though it may be worn to the point of needing repair. ...
Yes they are brass
Hi
Came across a couple boxes of these and was wondering if they are reloadable by using large primer load data with the small primer that fits them.
...
Am completing an M1 D, all USGI just not Army built, and was wondering if anyone has considered lining up the scope with the cross hairsintentionally "off" a bit to compensate for the offset of the...
Do you guys really use the witness marks for index? I have found that they are sometimes close but seldom right on. I line these up by the perpendicular center line of the receiver and the...
Depending on what was done, you may need a follower rod also.
George
I would try one of the Brown& Sharpe bolts. They seem to be "long".