Buttstock Spare Parts Container

[pcaru1]

Does anyone have or know where to get print drawings for the buttstock spare parts container? I have seen a few repros on E-bay but they go for a lot of money. I have not seen them anywhere else. I figured I would give it a go to try to make one myself. Doesn't seem to be that complex from the pictures I have seen. Thanks in advance.

Pictures are from the internet.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[emmagee1917]

Don't have the info you need , but I'd just measure a metal cleaning kit tube to start off and use the three parts as a guide . If you have a well equiped wood working shop , you might think about a run of these. I would bet a lot of people would like a cheep , fairly close copy for display.
Chris

[John Beard]

1. Go to Google.

2. Click on "more" at the top of the screen and select "Books".

3. Type "Colvin and Viall" in the box and click on "Search Books".

4. Select "United States rifles and machine guns" at the top of the screen.

5. Scroll down to page 242. This should depict what you're looking for.

Hope this helps.

J.B.

[pcaru1]

J.B.-Awesome!! Thanks.
P.

[pcaru1]

It took some trial and error but I finally got one to come out close to spec. It is made out of Maple cause it's cheaper than Black Walnut and I sent quite a few to the scrap pile before I got one to come out good. I found some Walnut dowels and will give it a go soon. It's more tricky to produce than it seems.

[scmcgeorge]

Please advise if you break the code and make a run of repro's I'd be interested. Steve McGeorge / stephen.c.mcgeorge@us.army.mil

[Ernest T. Bass]

I'm interested as well so if you get these to turn out the way you want them and can make some extras please let us know.

[MNCop]

Add me to the list as well. You could most likely sell a bunch if you make a good repro.

[Hibernianrifle]

Hello does anyone have a original or reproduction wooden spare parts container for the 1903 Springfield ?

[mark1]

Yes I have some repo 1903 parts containers. I made a batch of them. As it was stated there is a large scrap factor. The drilling of the walnut tube is difficult even with a jig I made to assist in drilling.
But I will need to look for them as after the move somethings are not were I remember they were.