Guys,

I recently acquired this critter. It was advertised as a "parts rifle" or for display. Mind you, every surface is stamped "DP". So it would take a bit of work to remove these marks, and to fully use them in other rifles...

BRITISH ENFIELD NO. 1 MK III DRILL RIFLE-DISPLAY

So here are some photos of it:



Magazine painted with stripes...





DP marked bolt.



Drilled hole in receiver through barrel.... Otherwise the rifle is intact. The barrel isn't welded in... no extra "clip" off the receiver.



DP marked nose cap.



Handguard repair! Small chunk falling out of it.



Rear sight is nice and clean, but has the DP mark.



Here is the receiver side. I can't quite make out who imported (?) this none rifle. I think it says:SPR SP(?) PN RN PA. There are additional markings about 2inches ahead of this... but I can't get a good photo.





The stock is stamped with various marks... and the DP stamp!



Here we have the brass buttplate. Sadly I checked to see if there were any hidden goodies... and its a no-go!



Thought or comments???
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.