Greetings,
I picked up my first M1icon carbine at my LGS. I got it fairly cheap because it was bubba'd up a bit for a homemade scope mount. Shoots and functions well. Bought it because it looked early and appeared mostly correct. (still have lots to learn though)

It's a Winchester, s/n 10807xx. The barreled action and trigger group look correct to me, except for the front and rear sights.

Besides being chopped for a scope's objective, the handguard is a two rivet marked Inland.

What is the correct Winchester handguard? I know it should be a two rivet, but I don't know if it should be deep groove, shallow, bullnose, or ???

How about the stock? "I" or oval? It has an oval and high wall, but it was chopped on the left side for the scope mount. Other parts are wrong too. Inland type 1A barrel band, SG recoil plate, ect.

Thanks for the help,
Eric
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.