I'm in the process of adding a 10 inch cleaning rod to my RC K98icon but at the present time I can only get it part way in. The cleaning rod is currently extending about 3 inches out past the end of the barrel. I did slide a shish kabob skewer into the cleaning rod holder and the skewer does go all the way to the cleaning rod lug nut but it is not seating all the way in?

I did spray some Hopps #9 in the hole and will try again tonight, Should the rod just slide in to the lug and then just screw on the 1/2" of threads or should it twist all the way down the hole.

Thanks in advance for your assistance.
Kind regards,
Dave
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.