1905 Ross MkII question

[Lucite]

I recently got in a 1905 Ross MK2 that unfortunately met bubba. The stock has been sanded and cut forward of the mid band with the upper wood being replaced by a No.4 mk1 upper rear hand guard and No4. mid band and sling swivel. Probably worst of all the length of barrel forward the front sight has been cut off but at least was nicely crowned. The receiver has been drilled and tapped and fitted with a Williams peep sight. As for missing parts from what I can see the list is as follows

• The front sight hood and screws

• nose cap

• mid barrel band

• rear sight assembly

• magazine cutoff spring

• butt stock sling swivel

• buttplate

Now my question is would someone by chance have a picture and dimensions for the magazine cutoff spring. By the description in the 1907 Ross manual "the cut off spring whose upper end has a point which enters vertically into a small hole in this projection. The lower end of the cut off spring has a similar point which enters a similar hole in the
top of the trigger guard." sounds like it would be fairly simple to duplicate with the right dimensions.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.