Hi
Just bought an m95 steyr carbine (cutdown rifle). Great looking rifle. One issue, loose fit. The stock does not seem dry. The outside had some kind of laquer applied and the inside had quite a bit of cosmo that I cleaned out. There are cracks in the wood between the trigger and the mag well. Also in the front block. See the pictures. At some point, staples were use to hold together. Side to side movement is minimal and will probably tighten with some BLOicon. Forward and aft movement are considerable (about 1/16"). Screws fore and aft on the magazine housing are tight. I'd like to shim but dont know where to put them. Also thought about wrapping the aft trigger guard screw as that's where the slack should be. Thoughts on the above or advise on how to tighten the fit?
Thanks in advance
Adam
Attachment 68801
Attachment 68800
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.