Hi guys
I need a little advice.
I have a type 38 carbine, i shoot with it at 200m
I group exelen. Horizontal perfect. Vertical 8-10 inch too the right.
After adjusted front sight a little.
I have now discovered that the rear sight base
Is slightly offset too the right.
And now the question:
If i loosen the screws. Is it posible to ajust it about 1 Degrés or so?
And is it then posible to refit the screws
With the base in a slightly new position?

Jsne
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.