I have a 1941 Husqavarna Swedishicon M38, 6.5x55 of course.

I want to disassemble it to give it a good cleaning, check for rust (none visible on the outside), etc.

After removing the magazine, and then the front and rear screws I was not able to pull out the trigger guard assembly. It may be stuck in there with some old cosmoine or something. Any ideas on how to get it out without messing up the wood or the metal?

Sidney
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.