used to have a nice weekly thread on home gunsmith how to,s but some guys whined, so i stopped, and this was one of the how to of the week..
so hear you go...
things you will need,
black elect, tape.
Dremil tool.
damascus cutting tool for said Dremil.
brass headed hammer.
tape the barrel ahead and behind the sight, as you will slip, and better th bugger the tape and not the barrel.
on the bottom of the sight, cut a notch, not all the way through but real close, take your time..
when you get it almost all the way through.
with a brass hammer, drive the sight hard by hitting the top of the sight, it will split the sight, and it will come right off.
then clean the area, and install the new sight base, make sure you put a bit of grease on the barrel so when you slide the sight over the barrel, it wont scratch the surface.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.