-
FREE MEMBER
NO Posting or PM's Allowed
1945 jungle carbine....
jungle carbine? can anyone help,i have just aquired a jungle carbine but the stock is not what usual jungle carbines have,it does not have the steel plate with sling attatchment or the recess where it should,it appears to be a regular stock,with a brass butt plate.the gun is of the 1945 vintage,does anyone know if they ever came like this,thanks in anticipation for your help.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by enfieldfan; 05-26-2010 at 01:09 AM.
Reason: adding photos
-
05-23-2010 10:35 PM
# ADS
Friends and Sponsors
-
Legacy Member
Pictures would help the pros (not me).
"Self-realization. I was thinking of the immortal words of Socrates, who said, "... I drank what?"
-
-
-
Legacy Member
"the gun is of the 1945 vintage,does anyone know if they ever came like this"
No, they did not come like that. There are many copies of the No5 out there---some built on No4 action bodies some built on the No1.
Assuming yours is not a No1, if the backsight support looks like the first photo below, it's been built out of a No4 by some importer.
If it looks like photo number two, it's a No5 with the wrong butt on it.
-----krinko
-
-
Legacy Member
How much are No.5 Mk.1s going for these days? I saw one at a local gun show (woodwork intact and not too dented, most of the original finish missing from the barrel, matching bolt) for $350. I was going to go back and look at it again, but I got a raging headache.
-
-
Legacy Member
If you are really lucky, it could be a Aussie made Lithgow
No.6 Mk1. These were Lithgows version of the No.5, but rather than being based on a No.4 action they were based on an Aussie No.III*. All the research that I have read indicates that the No.6 mk1 was built in very limited numbers with some of the production having No.3 butts and the balance having a version of the No.5 butts. To be a No.6 it should have a Lithgow receiver. If it does....Happy days - Paul
-
-
Legacy Member
The differences between a No4 and a No5 - note the 'lightening' cuts around the action (particularly between the rear sight pivot and the charger bridge) and the 'scalloped' barrel as it enters the action.
No4 on top, No5 below
-
-
Advisory Panel
And the differences between the No5 and the No6...
-
The Following 3 Members Say Thank You to Son For This Useful Post:
-
Legacy Member
Production numbers :
No5 (Faz & BSA combined) = 250,000
No6 Mk1 = 100 (one hundred)
No6 Mk1/1 = 100 (one hundred)
Not a lot of No6's about then !!!!!
Mine are not the best, but they are not too bad. I can think of lots of Enfields I'd rather have but instead of constantly striving for more, sometimes it's good to be satisfied with what one has...
-
Thank You to Alan de Enfield For This Useful Post:
-
FREE MEMBER
NO Posting or PM's Allowed
1945 jungle carbine

Originally Posted by
finloq
Pictures would help the pros (not me).
i will try and up load some photos later on today.it is a no.5 action with lightening around barrel and below sight ,behind charger bridge.thanks to all for your help.
-
FREE MEMBER
NO Posting or PM's Allowed
Some shooters don't care for the small pad on the No5 and change to a No4 butt stock.