-
Legacy Member
Information for Charlie Painter 777 on QH 1.6
Charlie, Checked the stock on the 1.603xxx QH; the inside of the sling recess is stamped RMC than a B not a P. On the other side is a small (.50 inch ? ) crossed cannon stamp 7 1/4 inches from the buttplate. Pistol grip flat has a large D and a small 2 which is a rack number, this stock is high wood
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
10-22-2010 09:27 PM
# ADS
Friends and Sponsors
-
Legacy Member
RCS, is that stock an I cut?.....Frank
-
-
-
Legacy Member
RMC stock
Frank, This stock has the I cut. Robert
-
-
FREE MEMBER
NO Posting or PM's Allowed
Sounds like IBM stock, need pics.
Scott
-
Legacy Member
Robert, Scott is right. The B in the sling well and the small CC would be for an early IBM (stock made by Rock-Ola).....Frank
-
-
Thanks RCS,
As I told you in the message I had just stumbled on that old post in which you asked about the proper rear sight. While I was researching staking on early QHMC flip sights yesterday.
After reading your description of the I cut Hi wood having a RMC and P in the slingwell with a small CC that close to the pistol grip. I thought it was a B instead of a P.
Didn't mean to butt in but had seen no one had replied about the stock marking.
Have heard that many of the original early QHMC carbines have just RMC in the slingwell, but have only personally seen a couple.
Wasn't sure if this would be good or bad news for you but figured you should know you have a early IBM stock.
Their really hard to come by.
Regards,
Charlie-painter777
See Questions asked by RCS in this original post.......
Beautiful Bringback, question is, how rare?
RMC B marked Hi-wood I cut......
-
-
Legacy Member
RMC stock
Thank you Charlie for the information about my stock. Next time I do some photos, I will take some of this stock. Robert
-
Thank You to RCS For This Useful Post: