-
Legacy Member
-
-
10-27-2011 12:05 AM
# ADS
Friends and Sponsors
-
Advisory Panel
That's just the action of the case deflecting off the op rod. Nothing unusual. M14s do it too so do carbines and ARs. Some don't but for the most part they do. I've seen them way worse and I still reload them.
-
Thank You to browningautorifle For This Useful Post:
-
-
Legacy Member
Thanks, Jim. It good to know nothing's wrong.
-
-
FREE MEMBER
NO Posting or PM's Allowed
Mine does the exact same thing, shes all good.
-
FREE MEMBER
NO Posting or PM's Allowed
And totally reloadable, but keep in mind the general rule is 4X use and recycle the brass. Gas guns like the M1 and M14/M1A are pretty tough on brass. You can switch the brass over to use in bolt guns if you're short on cases, but between the vigorous/violent extraction and the full length resizing, the cases will be too thinned above the case head to keep using in Garands after about the 4th trip through the gun.
Regards,
Brian in CA
-
Advisory Panel
Horse hockey. I've used brass as much as 20 times. Until it cracks at the mouth. Then it's done. They won't separate because there's no headspace problem.
-
-
FREE MEMBER
NO Posting or PM's Allowed
I've never made 20x reloads in a Garand but I have many cases that made it to 8-10x without any case head separations. I minimally full length size them and check cases in a case length gauge, trimming as needed. The dents you show in the pictures will easily size out during reloading & are very typical of cases fired in a Garand.