WRA parts Help

[cops504]

How can I tell WRA m14 parts? Are they all amrked or is just some of them marked. Do other parts have certain characteristics?

What is the hammer marked and the safety?

Thanks in advance for your help.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Maniac]

Winchester parts are marked with a CAGE code which would be 66118. I used to have a good site bookmarked for CAGE code lookup but can't find it. The other three M14 used their initials.

[Bill Hollinger]

Cops, Winchester parts are not all the time distinguishable from SA, HRA or IHC parts. They do have curtain characteristics often times. A rough milling job, a pin punch mark, and specific parts maybe a "CM" or an "A". The stocks have a curtain profile at the grip area and a "V" notch where the trigger housing locks. Also numbers stamped in the end under the ferrule. There are a lot of little subtle differences, too many to even try to list but it should be noted that none of the differences interfere with interchangeability between all of the manufacturers.

[emmagee1917]

Bill , M14 , not M1.
Arn't pain meds fun ?
Chris

[Harlan (Deceased)]

[Bill Hollinger]

Ha Ha! A blast! Oops . So used to seeing M1, sorry for that. Disregard last transmission, 10-22 that!

[RCS]

The Winchester
replacement M14 stock is stamped W-W over 11010263 between the two holes in the buttstock, this is a heavy stock