Jra 1903a4

[FTX03]

Hi, i have JRA 1903A4 replica which shoots great, i would like to put a scope with a 30mm tube on it, are there rings available that will go on to the original base? the planned scope would a redfield 3-9 or 4-12 power

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[vintage hunter]

AFAIK any standard turn in rings should fit. Be sure to grease the locking lugs of the front ring before installing to avoid galling.

[JGaynor]

Redfield 30mm Standard Rings

M1903A4's were equipped with Redfield Jr. Bases. Redfieled makes 30mm rings in two heights. (Per the link cited above.)
Leupold STD rings are compatible with Redfield Jr bases. Midway catalogs 30mm rings in four heights.

Since James River and all the clone builders use reproduction bases some fitting of the front ring may be required. Naturally the height of the rings will be governed by the objective bell of your scope and its clearance with the barrel guard. Ideally the scope should be mounted as low as possible but not contact the barrel guard.

[FTX03]

thanks guys