Quote Originally Posted by Aragorn243 View Post
Busted one screwdriver tip and bent three others.
You can also use the drill press but you need a second person. Unplug the drill press. Put the screw driver shaft and tip into the chuck and raise the table to as close as you can, hold the rifle on the table. The screw driver shaft needs to be lowered into the screw slot and held by one while the other turns the chuck by hand. If the tip is dressed correctly, the screw will give up. It's going to be a wide slot so there shouldn't be much trouble. Save drilling it out.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.